Installing the New Arcade Fishing System: Tips and Considerations

When it comes to installing a new Arcade Fishing system in your boat, there are several things you'll want to take into account to ensure a successful installation. In this article, we'll cover some key considerations and tips to keep in mind.

First and foremost, consider the water conditions where you plan to use your boat. A narrower boat than yours may not be as affected by waves or choppy water, but it's still important to take into account any potential issues with stability. In my experience, I didn't have any problems with the boat feeling tipsy when using the Arcade Fishing system.

Another consideration is the seating arrangement on your boat. If you plan to install a casting deck, be aware that removing the seats may violate federal upright and level flotation requirements. Make sure to add some kind of permanent floatation to comply with these regulations.

When installing the Arcade Fishing system, use nuts with nylon built into them as locking nuts to prevent water from seeping in and causing damage. Also, make sure to install any hardware or studs needed to secure the deck to the boat before encasing it in fiberglass resin. This will help prevent any issues with water damage or delamination of the plywood.

If you're using marine-grade plywood, you won't need to worry about encasing the entire piece in fiberglass resin. However, if you're using a non-marine grade material, it's a good idea to do so to ensure durability and longevity.

To hide any visible screws from the carpeted deck, use studs with prongs that will sink into the plywood and prevent them from turning when you put the nut on. Finally, consider rolling the carpet over the edge of the decking material and gluing it to the bottom of the deck for a clean, finished look.

By following these tips and considerations, you'll be able to install your new Arcade Fishing system with confidence and enjoy many hours of fishing fun on the water.

Instal the new Arcade Fishing